Anyone have Installation papers 1 and 2 for 2011? and answers?
Thanks
Mikep
Anyone have Installation papers 1 and 2 for 2011? and answers?
Thanks
Mikep
no problem pm me your Email address and I will send what i have.
Hi @cvmostert i sent you a pm with my mailing address could you please send me a copy as well?
many thanks for the papers chris
Hi there, has anyone worked out the question 1 of paper 2 November 2009?
The figure is as follows:
(db-220V DC) ----10mCable----(C1-50A)----9mCable----(C2-40A)----8mCable----(C3-30A)----7mCable----(C4-20A)
If this is not understood i can draw and post also.
The questions are:
1. use the figure and calculate the minimum cable size
2. calculate the voltage drops between the distribution board and the circuits c1 to c3 in each case
3. prove that the same copper cable was used.
Tables available: E.1 and 6.4(b)
I was using the VD = 2 x I x (resistivity x L)/A equation
Let me know your thoughts, Thanks!
Guys I need some help here.
I'm writing Installation Rules, papers 1 & 2 very soon.
But I need desparately the following documents:
SANS 1973-3
SANS 10198-2
SANS 10198-1
SANS 10292
I have memos and questions papers for both from 2007 that I cann share with anyone in need.
I also have the following study material.
OHS Act 85 of 1993.pdf
OHS Acts, 1993-Construction Regulations, 2003.pdf
OHS Acts, 1993-Electrical Installation Regulations, 2009 .pdf
OHS Acts, 1993-Electrical Machinery Regulations 2011.pdf
SANS-10142-1, 2009.pdf
SANS-10142-2, 2009.pdf
Syllabus, 2009.pdf
Regards
Loyiso
At least one of the documents you're looking for is available from wwwdotscribddotcom. I'm not going to go into any more detail in case Dave gets extradited to the US under the new piracy laws..
_______________________________________________
_______________________________________________
AndyD (01-Feb-12)
Hi Loyiso, Send me a PM and I'll send you old papers for 1 and 2.
Did you like this article? Share it with your favourite social network.