Hello : )

Been reading but not so active sorry gents.

Will try update the other topic I had from Friday.

Went out to look at an inverter install this morning, a bunch wrong but one that I am playing bat and ball with is that the inverter supply i.e the output of the inverter it goes through a CB in the change over board but when it enters the main DB where the circuits are there is no Main Switch.

So basically to isolate the board you have to switch off the triple pole in the main DB for Eskom then go to the inverter change over board to isolate that main switch to then have the main DB isolated.

So now, if you put labels stating switch of main switch for inverter at X location is that ok ? Or must there be a main switch for the inverter output (supply) in the main DB as well so that both main switches are operated quickly and same place ?



Sent from my CPH2197 using Tapatalk