Results 1 to 3 of 3

Thread: Question relating to old installation (1974)

  1. #1
    Full Member
    Join Date
    Sep 2015
    Location
    port elizabeth
    Posts
    26
    Thanks
    0
    Thanked 1 Time in 1 Post

    Question relating to old installation (1974)

    Evening all

    I am currently busy with a inspection on a house that was build in 1974 and I came across a light in the garage that is getting supply from a socket outlet. So my question is do I disconnect the light from the socket outlet circuit or would it be suitable to attach a warning notice at the light switch stating it's supplied from socket circuit and also attach a label "mix circuit" on the DB below the plug circuit it is fed from. The installation complies with the general safety principles except +- 6 lights in the house that's wired with ripcord.
    Your inputs will be much appreciated.

  2. #2
    Diamond Member AndyD's Avatar
    Join Date
    Jan 2010
    Location
    Cape Town
    Posts
    4,404
    Thanks
    513
    Thanked 855 Times in 688 Posts
    If the ripcord is in steel conduit and it's got asuitable voltage rating and it's supplying ClassII light fittings it might be legal. I don't know of any regulation off hand that forbids a light being supplied from a socket as long as the socket is single phase, not rated at more than 16A and is protected by a 30mA RCD.
    _______________________________________________
    I am special and so is Vanash.
    _______________________________________________

  3. Thanks given for this post:

    DPCK (02-Sep-16)

  4. #3
    Site Caretaker Dave A's Avatar
    Join Date
    May 2006
    Location
    Durban, South Africa
    Posts
    20,981
    Thanks
    3,056
    Thanked 2,463 Times in 2,068 Posts
    Blog Entries
    12
    I'm unclear from the above as to whether the light is wired in directly or if it is on a plug top.

    Assuming it is wired in directly, the answer is to mark the circuit as "mixed" (or quite often I'll see the circuit marked as "Garage"), and to make sure the over-current protection is appropriate to the conductor (make sure the light is wired in 2.5mm if on a 20A circuit breaker).
    The trouble with opportunity is it normally comes dressed up as work.

Similar Threads

  1. [Article] Installation Rules Paper 2 (April 2010 Exam Question 1) Answer
    By Fikani2010 in forum Electrical Contracting Industry Forum
    Replies: 2
    Last Post: 21-Nov-17, 09:38 AM
  2. Question 1 Installation Rules Paper 2 Nov 2010
    By Mzizi in forum Electrical Contracting Industry Forum
    Replies: 1
    Last Post: 13-Sep-15, 09:37 PM
  3. [Question] A Couple of CC Questions Relating to Profit Sharing and Expenses
    By rfnel in forum General Business Forum
    Replies: 21
    Last Post: 20-Jul-11, 04:34 PM
  4. Replies: 0
    Last Post: 12-Aug-08, 07:14 PM

Did you like this article? Share it with your favourite social network.

Did you like this article? Share it with your favourite social network.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •